ARRI IVS Manuel d'instructions télécharger pdf (Page 23)

4.4.1.2 Y/C Outputs

In comparison to the composite outputs, the Y/C outputs

offer the even better S-VHS quality. There are also ”normal

video” and ”video with data” signals available.

Y/C on the BNC connectors is only available when

BNC Y/C is selected on the menu.

Please see chapter 6.4.9 ”Composite or Y/C signal at

BNC Connectors”.

To change from ”normal video” to ”video with data” and

vice versa, please see chapter 6.4.8 ”Y/C-Output as

‘normal video’ or ‘video with data’ ”.

In the ”normal video” mode almost no electronic information

is inserted. Only a flashing bar at the bottom left corner

of the video image indicates a running film camera.

In the ”video with data” mode additional data like format

markings or time code can be inserted.

Y/C signals either in the mode ”normal video” or in the

mode ”video with data” can be taken from two different

connectors on the IVS: The BNC sockets or the standard

S-VHS connector on the lower side of the IVS §.

For signals from the S-VHS connector please use the

standard S-VHS cable, which was delivered with the IVS.

Note: This cable is secured by a spring §.

To release, please press the spring and pull the

cable out.

Setup

Y/C Output •Spring •

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 124 125

Pas de commentaire

ARRI IVS Manuel d'instructions Page 23